THE TECNO-BUILD® BEARING STRUCTURE IS DESIGNED TO BE FITTED OUT WITH ANY KIND OF PERIMETER WALL REQUIRED BY THE CUSTOMER.

IN ORDER TO ENSURE ‘VENTILATION’ OF ALL OUTER SURFACES OF THE CONSTRUCTION – AND THE RELEVANT ADVANTAGES IN TERMS OF LIVING COMFORT AND LACK OF INDOOR HUMIDITY – WE PROPOSE TWO TYPES OF PERIMETER WALLS.

TYPE 1:

The wall consists of:

  • A primary structure made up of a series of frames of pressure-bent, galvanized steel (width: 100 cm; thickness: 6 cm; height: design height of the wall), properly reinforced with cross-beams of pressure-bent, galvanized steel, joined by riveting and without welding; the structure is properly perforated in order to allow air recirculation to and from the neighbouring components of the bearing structure, as well as passage of the components of the hydraulic and electric installations located inside the structure itself.
  • Outside the primary structure, a 12 cm thick, self-bearing, security sandwich panel is installed, consisting of two sheets of pre-painted, galvanized steel, each 0.4 mm thick, with polyurethane insulation between them. The outer (visible) finishing can be chosen by the Customer among various proposals (stone effect, brick effect, plaster effect, etc.).
  • Inside the primary structure a sheet of galvanized steel is installed, completely covering the surface; plasterboard sheets shall be subsequently applied on it, grouted, levelled and painted. Thanks to these two elements, you can securely hang wall units, paintings and fittings wherever you want.
  • The total thickness of the wall is comprised between 19 cm and 21 cm according to the outer finishing chosen by the Customer.
  • This type of wall is high-performing, having a heat transfer coefficient of 0.17 W/m2K, and therefore it is recommended in housing structures where thermal insulation plays a critical role.
  • All wall components are recyclable.

TYPE 2:

  • The wall consists of a series of PVC slats.
  • Each slat has the following dimensions: width: 15 cm; depth: 7 cm; thickness: 3 mm: height: design height.
  • Inside, the slat is divided into six chambers that perform various functions, i.e.:
  • Allowing air passage and, as a result, a high-value ventilation as already discussed.
  • Allowing passage of the hydraulic and electric installations.
  • Allowing to securely hang wall units, paintings and fittings at an U-shaped element of pressure-bent, galvanized steel located in the central chamber of each slat.
  • The wall is obtained by assembling several slats fitted together through pressure or sliding. Thanks to PVC modular elements, the slats can be positioned at edges, and they can also be combined with blind partition walls.
  • This type of wall is most suited when the construction shall be used for initial reception and commercial purposes, especially in case of temporary / seasonal use, i.e. when there is a need to disassemble and reassemble it several times.
  • This type of wall is recommended in constructions where hygiene and sanitization play a vital role; indeed, it is compatible with the use of high-pressure washers.
  • This type of wall has a heat transfer coefficient of 0.69 W/m2K, and therefore it is recommended in commercial constructions (kiosks, toilets, etc.).
  • The wall of PVC slats can be coated both internally and externally with plasterboard sheets and finished according to your wishes.
  • The total thickness of the wall is comprised between 7 cm and 10 cm according to the outer and inner finishing chosen by the Customer.
  • All wall components are recyclable.